kmfkcover.blogg.se

Lightburn settings continue connecting lines
Lightburn settings continue connecting lines








lightburn settings continue connecting lines

The last one could be the issue - the C3D ships with relatively conservative settings for motor current, and you can change those on the SD card. Line shifting isn’t a totally uncommon problem with the C3D, and the most common causes are going too fast, poor grounding, or not having the settings adjusted properly. You can save that GCode as a text file and run it in a variety of online GCode simulators to prove (or disprove) that the GCode is correct. LightBurn doesn’t send “signals”, really, it’s just gcode in a text file. Some of the settings, particularly ‘Flood Fill’ can make the machine bounce around a lot, and that can result in gaps unless the machine is really accurate. It’s not the software directly, as if it was it would be far more than you having the issue. It could be settings - if you can include those I can have a look and make suggestions based on that. Same place, regardless of where the print is, so it’s unlikely hardware. Any help figuring out these problems are appreciated.Īlso, even with bidirectional enabled, it’s missing lines. To get high-quality prints I’m having to keep swapping back to the cheap Chinese board that came with it and using K40 Whisperer. This has happened repeatedly, but most of those pieced have personal information on them, so I just made this to show ya’ll what it’s doingĪlso, even with bidirectional enabled, it’s missing lines.

lightburn settings continue connecting lines lightburn settings continue connecting lines

It’s not just text, it’ll slant graphics (or parts of graphics) just the same. Notice that the top and bottom lines of text are slanted. In this scrap picture, the TOP is with bidirectional enabled. Preview looks good in all cases, but the errors are consistent, so it definitely seems like Lightburn is sending the incorrect signals to the board. For example, straight text will look italicized, and it happens in the same place spot of the print every time, regardless of where the print is on the bed. With bidirectional disabled, things get tilted. That being the case, I disabled Bidirectional to see if that improves it. The quality has been an issue, so I was thinking it might be a slight offset issue. I recently got the Cohesion Laserboard and I’m having a hell of a time dialing in the settings.










Lightburn settings continue connecting lines